The Base Station will be updated and you’re done with AirPort Utility. Verify that the hard drive you connected to the AirPort Extreme is shown in the pane. Tweak this window as you like and click the Update button to save the settings. (It’s in Applications Utilities.) The window shown below appears. The network settings on the AirPort Extreme are now reset back to factory defaults, and you. Allow a full minute for the AirPort Extreme to restart back to a slow, blinking amber light status. Additionally, you can configure guest access from a pop-up menu (Not Allowed, Read Only, and Read and Write), enable WAN access, and configure the disk(s) for Windows File Sharing. Power up the old AirPort Extreme for a minute or two, then hold in the reset button on the device for 8-10 seconds and release. This is where you make the disk(s) tethered to the Base Station available to your Macs as well as determine which password will be used to access them (options include each account’s password, a disk password you create, or the password required to edit the Base Station’s settings). In that same window, click the File Sharing tab. (If you’ve plugged a USB hub into the Base Station and attached multiple hard drives to it, you’ll see all the devices plugged into that hub.) Wi-Fi Protected Access (WPA/WPA2) 2 Wireless security (WEP) configurable for 40-bit and 128-bit encryption MAC address. The 4th Generation AirPort Extreme Base Station (Model Number A1354) is a wireless access point for home, school, or small business. AirPort Extreme Base Station Power supply with cord Printed documentation Security. Click that and you should see the name of the disk connected to the Base Station. NAT, DHCP, PPPoE, VPN Passthrough (IPSec, PPTP, and L2TP), DNS Proxy, SNMP, IPv6 (6to4 and manual tunnels) Included in the box. In the window that appears, you’ll see a Disks tab. You can find MAC address on the label on the bottom or side of the device.Select the Base Station within the AirPort Utility window and click the Manual Setup button. *A MAC (Media Access Control) address, also known as a "network ID," is a hardware identification number for a network port. AirPort base station network names are "Apple Network xxxxxx," where xxxxxx is the last six digits of the wireless MAC address*.AirPort base station names revert to "base station xxxxxx," where xxxxxx is the last six digits of the wireless MAC address*.AirPort base station passwords are "public." While more compact and in some ways simpler than another Apple Wi-Fi base station, the AirPort Extreme, the Express offers audio output capability the Extreme.AirPort base stations are set to request an IP address by DHCP.When you set up your AirPort Extreme Base Station, it creates two high-speed Wi-Fi networks: Â A 2.4 gigahertz (GHz) network for 802.11b, 802.11g, and 802. AirPort Extreme provides simultaneous dual-band wireless 802.11n networking. Your AirPort Base Station will have the following Settings After Reset: AirPortExtremeBaseStation.Readthisguidetogetstarted. The reset button is located next to the last LAN port and is inside of a small capsule-shaped hole. Using a narrow object (such as a straightened paper clip), press and hold the reset button for 5 seconds or until the light on the front of the device starts flashing in an amber color. Unplug your base station from all power sources.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |